Setting up a Brick Paver Walkway or Big Grey Bricks

The use of Bricks or Pavers to create a walkway or patio area complements a home in a method that is unmatched. In addition, setting up a Brick or Paver sidewalk does not always require a pro.

The secret to installing a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be set up. The area needs to be dug out a minimum of a foot down, eliminating all topsoil and clay soil. In addition, string lines should be strung on each side of the pathway. The string lines indicate the completed height of the sidewalk.
As soon as the location has been dug down, 3/4" gravel stone ought to be laid in and tamped down securely. Then 2" of sand, or stone dust ought to be topped the gravel. Again the sand/stone dust need to be tamped down. Stone dust is preferred. The height in between the tamped down sand and the stringline ought to equate to the density of the brick or paver.

Now that you have a steady base, place a 1" pipeline or ledger board the length of the pathway on either side of the pathway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level surface area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Install a work on both sides of the prepared area. These strips will function as your sidewalk border and help to keep the integrity and shape of the pathway. You can get these plastic strip borders at a lot of house improvement shops. The strips must here be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.

The secret to laying the bricks/pavers is to guarantee that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will again assist maintain the integrity of the sidewalk.

Undoubtedly bricks/pavers will need to be cut or divided when developing the sidewalk. To in fact cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you desire to break the brick. If your walkway has curves you will need to buy/rent a wetsaw.

After installing the bricks, construct up the outside edges with extra sand, and then shovel in the topsoil and load down firmly.
Spread stone dust over the brand-new pathway and sweep into the fractures. Repeat this process a couple of times to ensure the fractures are fully filled. This will complete the interlocking of the bricks and assist to remove any weed growth. Just include lawn seed to white bricks the outside edges and you should have a stunning entrance to your home within a couple of weeks.


In addition, setting up a Brick or Paver pathway does not always require a pro. The key to setting up a Brick or Paver Walkway is to first appropriately prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, place a 1" pipeline or journal board the length of the pathway on either side of the pathway. These strips will act as your pathway border and aid to maintain the integrity and shape of the sidewalk. Inevitably bricks/pavers will require to be cut or divided when developing the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *